Short Story: The Truth About nano hemp oil

nano hemp oil

Will require about two gallons of solvent to strip the phc off one pound of dry starting material milliliters of solvent should be more than enough to strip the DHC from one ounce of hip starting material.

Three crush the plant material using a stick of clean untreated wood or some such device even though the starting material has been dampened with the solvent you will find that the material can be readily crushed for add solvent until the starting material is completely covered.

Use the stick to worth of plant material as you are doing this the phc dissolves off the plant material into the solvent continue this process for about minutes pour the solvent oil mix off the plant material into another bucket you have just stripped the plant material of about eighty percent of its THC seven second wash again add solvent to the plant material.

And work it for another three minutes to get the other twenty percent eight pour this solvent oil mix into the bucket containing the first mix that was poured off previously nine discard the twice washed plant material pour the solvent oil mix through a coffee filter into a clean container boil.

The solvent earth I have found that a rice cooker wilderness boil off very nicely the i have has two heat settings high and low and will hold over a half gallon of solvent oil mix and solvent oil mixed to the rice cooker until it is about three quiet is full.

Please make sure you’re in a very well ventilated area and set up a fan to carry the solvent fumes away the fumes are very flammable be sure to stay away from red-hot elements sparks cigarettes EGC that could ignite the fumes plug the rice cooker in and set it on high heat continue adding solvent oil mixes the level in the rice cooker decreases until it is all in the cooker.

Add a few drops of water to the solvent oil mix as the level comes down for the last time the amount of water added depends on how much starting material you had in the beginning if I’m producing oil from a pound of good but I usually add about ten drops of water.

When there is about one inch of solvent oil water mix left in the cooker put on your oven mitts pick the unit up and gently swirl the contents continue swirling until the solvent has been evaporated off the few drops of water help release the solvent residue and protect the oil somewhat from too much heat when the solvent has been boiled.

Get More :-Thrtech.com